Lexicon 300, Owner'S Manual

Page: 47 / 155

Lexicon
300 V 3.0 Owner's Manual
3-18
The 300 is shipped with 100 effect presets. Sooner or later you will want to alter
the sounds of these effects to more perfectly fit your requirements. To do this,go
to Run mode and load a preset setup that uses the effect you want to edit — or
select and load the effect you want to edit from Page One in Setup Edit mode.
Once the setup is loaded, pressing EFFECT EDIT will put you in Effect Edit
mode with the display showing one page of the parameters available for the
algorithm driving that effect.
The algorithms and their parameters are described in detail in Chapter 4. We've
chosen the first page of Random Hall parameters to show here as an example:
RTIM SIZE ROLL PDLY
RLVL TDCY BASS XOVR
The buttons directly above and below each display entry will select that
parameter. Once selected, parameters can be adjusted over their entire range
with the Soft knob. The parameter and its current value will appear on the display
as long as the Sof tknob is being adjusted. In the example above, "RTIM" has
been selected — turning the Soft knob will alter the parameter value, and cause
the display to show:
Pressing the front panel VALUE key will display all of the current parameter
values for the selected page. in this example, pressing VALUE will cause the
following display to appear:
Effect Edit Mode
Parameter Selection
CONTROL SETUP
SELECT
MACH
STORE
VALUE
SETUP
EDIT
EFFECT
EDIT
MOD
EDIT
Mid Reverb Time
XX.XX seconds
XX.Xs 37.1M 2.9k 2 2 m
FULL 3.6k 1.2X 0.5k