Lexicon 300, Owner'S Manual

Page: 112 / 155

Lexicon
300 V 3.0 Owner's Manual
5-20
For your reference, all of the presets effects available in the split mode are listed
and described below, in numerical order.
Split Setup
Effect Descriptions
EP # Name Algorithm Description
601 *Dual Delays Dual Delays Baseline effect with the Soft knob patched to the last two delay lines
in the signal path. Advancing the Soft knob parameter will cause the
two post-delays to move in sync out to more than 2200ms.
602 Space Delays Dual Delays This preset incorporates a bit of left-right diffused delay along with
some small delay offset between left and right delay outputs. If the
effect is too strong you could try turning back the feedback levels for
Delays 3 and 4.
603 *Pingo Pongo Dual Delays Ping - Pong delays bouncing back and forth. The Soft knob
parameter controls the timing of the bounce.
604 *3Voice Dlys Dual Delays Two taps (Delay 3 and 4 ) are set with delay ratios of 1:2 —
meaning when one is 200ms the other is 400ms, or when one is 359
the other is 718ms. This relationship is patched to the Soft knob.
605 OverTheTop1 Dual Delays This preset should be used pretty much through the box, i.e. send it
a pre-fader signal then mix only the returns. Flange Delay is
patched to the LFO. When properly modulated, the flange delay
glides between 9.5 and 18.7ms. The base delays are set to 10ms
with a positive feedback gain. Over the top cancellation occurs as
the glide delay passes over the 10ms base delay. Remember, the
LFO is part of the Setup, so if you load the effect into a Setup where
there is no LFO activity, the preset will sound “hollow” and resonant!
606 OverTheTop2 Dual Delays Similar to OverTheTop1 except the flange delay glides between
0.08 and 10.7ms. Flange Delay is patched to the LFO. The base
delays are set to 10ms with a negative amplifier gain. Over the top
cancellation occurs as the glide delay passes over the 10ms base
delay. The channel outputs are reversed such that the left input will
pass through to the right output and vice-versa. Remember, the
LFO is part of the Setup, so if you load the effect into a Setup where
there is no LFO activity, the preset will sound “hollow” and resonant!
607 LFO:FazeDlys Dual Delays Faze Dlys also makes use of the LFO again to the Flange Glide
Delay (FGLD). The base delays are set in different time domains;
one side at 1.9ms with a feedforward gain and the other at 5.6 with
a negative feed gain. As the glide passes over each base delay the
phase of each gain is changed and in between the output is a
mixture of each. A great effect on a ripping guitar solo.
608 Env:Phazer Dual Delays This preset makes use of a patch between the envelope detector in
the meters and the Flange Glide Delay. As signal becomes
stronger the glide delay drops in time domain eventually crossing
the 5.2 ms base delays. As audio signal strength lessens the glide
returns to its preset value of 10ms. Very good on vocals. To make
this effect work properly be sure to drive the 300 to within 12dB of
full scale (dBfs).