223
Displaying Port Security Port Status
Use the Port Security Port Status page to show the entries authorized by port security
services, including MAC address, VLAN ID, time added to table, age, and hold state.
PATH
Monitor \ Security \ Network \ Port Security \ Port
Figure 103: Port Security Port Status
PARAMETERS
These parameters are displayed:
◆
MAC Address
– The MAC address seen on this port. If no MAC addresses are learned, a
single row stating “No MAC addresses attached” is displayed.
◆
VLAN ID
– The VLAN ID seen on this port.
◆
State
– Indicates whether the corresponding MAC address is blocked or forwarding. In the
blocked state, it will not be allowed to transmit or receive traffic.
◆
Time Added
– Shows the date and time when this MAC address was first seen on the port.
◆
Age/Hold
– If at least one user module has decided to block this MAC address, it will stay
in the blocked state until the hold time (measured in seconds) expires. If all user modules
have decided to allow this MAC address to forward, and aging is enabled, the Port Security
module will periodically check that this MAC address is still forwarding traffic. If the age
period (measured in seconds) expires and no frames have been seen, the MAC address
will be removed from the MAC table. Otherwise a new age period will begin.
If aging is disabled or a user module has decided to hold the MAC address indefinitely, a
dash (-) will be shown.
Summary of Contents for GEP-1070
Page 80: ...80 authentication from any point within the network...
Page 168: ...168...