170
VLAN Membership
Use the VLAN Membership Configuration page to enable VLANs for this switch by assigning
each port to the VLAN group(s) in which it will participate.
PATH
Configuration \ VLANs \ VLAN Membership
Figure 67: VLAN Membership Configuration
PARAMETERS
These parameters are displayed:
◆
VLAN ID
–
VLAN Identifier. (Range: 1-4095)
◆
VLAN Name
–
The name of a VLAN. (Range: 1-32 alphanumeric characters)
◆
Port Members
–
Port identifier.
Port overlapping can be used to allow access to commonly shared network resources among
different VLAN groups, such as file servers or printers. Note that if you implement VLANs
which do not overlap, but still need to communicate, you must connect them through a router.
WEB INTERFACE
To configure IEEE 802.1Q VLAN groups:
1. Click Configuration, VLANs, VLAN Membership.
2. Change the ports assigned to the default VLAN (VLAN 1) if required.
3. To configure a new VLAN, click Add New VLAN, enter the VLAN ID, and then mark the
ports to be assigned to the new group.
4. Click Save.
VLAN Ports
Use the VLAN Port Configuration page to configure VLAN attributes for specific interfaces,
Summary of Contents for GEP-1070
Page 80: ...80 authentication from any point within the network...
Page 168: ...168...