119
3. Specify the LACP Admin Key to restrict a port to a specific LAG.
4. Set at least one of the ports in each LAG to Active initiation mode, either at the near end or
far end of the trunk.
5. Click Save.
4.7. Loop Protection
This page allows the user to inspect the current Loop Protection configurations, and possibly
change them as well.
PATH
Configuration \ Loop Protection
Figure 44: Global Configuration for Loop Protection
PARAMETERS
These parameters are displayed:
General Settings:
◆
Enable Loop Protection
– Controls whether loop protections is enabled (as a whole).
◆
Transmission Time
– The interval between each loop protection PDU sent on each port.
valid values are 1 to 10 seconds.
◆
Shutdown Time
– The period (in seconds) for which a port will be kept disabled in the
event of a loop is detected (and the port action shuts down the port). Valid values are 0 to
604800 seconds (7 days). A value of zero will keep a port disabled (until next device
Summary of Contents for GEP-1070
Page 80: ...80 authentication from any point within the network...
Page 168: ...168...