Lenz Digital plus LH101, Operating Manual

Page: 217 / 331

Appendix 105
16.3 Trouble shooting
Problem Possible cause Solution
Locomotive does not run Wrong locomotive address
on the display Enter correct locomotive
address
.
(

p. 17)
Locomotive address on
the display, but pressing
operating keys yields no
response
You are in the address
selection mode of the
command station memory,
indicated by an “A” in the
bottom line.
Press 'Enter'.
Speed step mode
cannot be changed Locomotive speed is not 0 Set the speed to 0 before
setting the speed step mode.
Locomotive lighting (F0)
goes on and off when
speed steps are
increased The locomotive decoder is
set to the 14 speed step
mode, the corresponding
address in the digital
system is set to the 28
speed step mode. Change the speed step mode
in the system to 14 speed
steps (

p. 25)
or
set the decoder to 28 speed
steps (set bit 2 in CV29)
Locomotive lighting (F0)
does not respond when
pressing The locomotive decoder is
set to the 28 speed step
mode, the corresponding
address in the system is
set to the 14 speed step
mode. Change the speed step mode
in the system to 28 speed
steps (
 p. 25)
or
set the decoder to 14 speed
steps (clear bit 2 in CV29).
The locomotive decoder is
set to the 14 speed step
mode, the corresponding
address in the system is
set to the 128 speed step
mode Change the speed step mode
of the locomotive decoder to
28 speed steps (set bit 2 in
CV29).
Locomotive address on
the display flashes Selected address has
already been called up by
another manual control Select another locomotive or
take over the locomotive by
pressing the rotary knob.
Locomotive does not run
with its basic address
read out on the
programming track Locomotive may be part of
a multiple traction. The
MTR address can be found
in CV19 of the locomotive
decoder. Control the locomotive with
the multiple traction address
or delete the MTR address in
CV19.
The locomotive is set to
operation with a 4-digit
address (bit 6 is set in
CV29). Control the locomotive with
the 4-digit address. If you do
not know the address, read it
out on the programming track.
Information on how to proceed