Lenz Digital plus LH101, Operating Manual

Page: 188 / 331

76 Operating manual LH101
Make sure you do not exceed the valid value range of the decoder when entering the
numeric value in the CV! If needed, refer to the operating manual of the decoder.
CV7 (version number) and CV8 (manufacturer identification) can only be read out, but
not entered.
13.3.5 Reading out and programming a register
The register mode is besides the CV mode a possibility to change
settings in locomotive decoders.
Strictly speaking, it is the "original" technique used to make decoder
settings in the DCC system. This method was replaced more than 20
years ago by better CV programming.
Action Display Explanation
The starting point is locomotive control
Switch to the general menu
Select the relevant menu item ...
... and confirm your selection.
If necessary, turn the knob until "Program
register" appears ...
... and confirm your selection. You are now
prompted to enter the register whose value
you want to read or change.
Enter the number of the register with the
keys ...
(press the key to correct your entry if
necessary)
... and confirm the entry by pressing the
'Loco' key.
The register is now read out immediately …