Lenovo ThinkServer TS200v, Hardware Maintenance Manual

Page: 55 / 108

This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the server and
wait three to five minutes to let the server cool before removing the server cover.
To replace the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
2. Remove the server cover. See “Removing the server cover” on page 33.
3. Lay the server on its side to get easier access to the system board.
4. Remove the heat sink and fan assembly from the system board. See
“Replacing the heat sink and fan assembly” on page 47.
5. Lift the small handle
1
and open the retainer
2
to access the
microprocessor
3
.
6. Lift the microprocessor straight up and out of the socket.
Notes:
a. Your microprocessor and socket might look different from the one
illustrated.
b.
Note the orientation of the microprocessor in the socket. You can either
look for the small triangle
1
on one corner of the microprocessor or note
the orientation of the notches
2
on the microprocessor. This is important
when installing the new microprocessor on the system board.
Chapter 6. Replacing FRUs
49