Lenovo ThinkServer TS200v, Hardware Maintenance Manual

Page: 44 / 108

7. Pivot the PCI card latch to the closed position to secure the PCI card.
8. To complete the installation or replacement, go to “Completing the parts
replacement” on page 61.
Replacing the battery
Attention
Do not open your server or attempt any repair before reading and
understanding the Chapter 1, “About this manual,” on page 1 and the
Safety
Information book. To obtain a copy of the Safety Information book, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the battery.
Your server has a special type of memory that maintains the date, time, and
settings for built-in features, such as parallel-port assignments (configuration). A
battery keeps this information active when you turn off the server.
The battery normally requires no charging or maintenance throughout its life;
however, no battery lasts forever. If the battery fails, the date, time, and
configuration information (including passwords) are lost. An error message is
displayed when you turn on the server.
To replace the battery, do the following:
1. Remove all media from the drives and turn off all attached devices and the
server. Then, disconnect all power cords from electrical outlets and disconnect
all cables that are connected to the server.
Figure 9. Installing a PCI card
38
ThinkServer TS200v Types 0981, 0992, 1008, and 1010: Hardware Maintenance Manual