Used to connect the cable of the corresponding system fan.
33
Front backplane power connector
Used to connect the power cable from the backplane.
System board jumpers
The following illustration shows the jumpers on the system board of your server.
Figure 26. System board jumpers
Table 2. System jumpers
1
Clear password jumper
2
BIOS default settings jumper
3
BIOS recovery jumper
4
Jumper cap storage
Attention:
To set the jumpers, you need to remove the server cover to access the system board. Do not
open your server or attempt any repair before reading and understanding “Safety information” on page iii
and “Guidelines” on page 59.
1
Clear password jumper
(Default setting: open)
Used to erase forgotten passwords, such as the BIOS passwords.
To clear passwords, do the following:
1. Remove all external media from the drives and turn off all attached devices and the server. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to
the server.
2. Prepare your server. See “Removing or extending the server from the rack cabinet” on page 61.
3. Remove the server cover. See “Removing the server cover” on page 61.
4. Locate the clear password jumper
1
on the system board. Then, remove any parts and disconnect any
cables that might impede your access to the jumper.
40
ThinkServer RD550 User Guide and Hardware Maintenance Manual
Summary of Contents for ThinkServer RD550
