Lenovo ThinkCentre M83, Hardware Maintenance Manual

Page: 188 / 308

Note: When the computer is turned on for the first time after replacing the battery, an error message
might be displayed. This is normal after replacing the battery.
10. Turn on the computer and all attached devices.
11. Use the Setup Utility program to set the date, time, and any passwords. See Chapter 5 “Using the Setup
Utility program” on page 55.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 234.
Installing or replacing the mSATA solid-state drive
This section provides instructions on how to install or replace the mSATA solid-state drive.
Note: The mSATA solid-state drive is only available in some models.
Installing the mSATA solid-state drive
Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 “Safety information” on page 1.
To install the mSATA solid-state drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 159.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 160
4. Press the retaining clip 1 in the direction as shown and pivot the drive bay assembly upward at the
same time.
Figure 135. Pivoting the drive bay assembly upward
5. Take the new mSATA solid-state drive and the storage converter out of its static-protective package.
180
ThinkCentre M83 and M93/p Hardware Maintenance Manual