Lenovo 10AQ, Maintenance Manual, Page: 91 / 184

4. To reinstall the front bezel, align the three plastic tabs on the right side of the front bezel with the
corresponding holes in the chassis, then pivot the front bezel inwards until it snaps into position on
the left side.
Figure 13. Reinstalling the front bezel
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 122.
Replacing the hard disk drive
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and
Setup Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the hard disk drive.
To replace the hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 85.
3. Locate the hard disk drive. See “Locating internal drives” on page 74.
Note: There is also a secondary hard disk drive bay for you to purchase and install a secondary hard
disk drive by yourself. If you want to install a secondary hard disk drive, use the same way of installing
the hard disk drive.
4. Disconnect the signal cable and the power cable from the hard disk drive.
Chapter 9
.
Replacing FRUs (machine type: 10AR)
87