Lenovo 10AQ, Maintenance Manual, Page: 142 / 184

Figure 76. Installing the screw to secure the bracket on the bottom of the optical drive bay
12. Connect one end of the signal cable to the bottom of the new solid-state drive and the other end to
an available SATA connector on the system board. See “Locating parts on the system board” on
page 80. Then, locate an available four-wire power connector and connect it to the bottom of the
new solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 169.
Replacing the system fan
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and
Setup Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the system fan.
To replace the system fan, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 126.
3. Remove the front bezel. See “Removing and reinstalling the front bezel” on page 127.
4. Pivot the drive bay assembly upward to access the system fan. See “Accessing the system board
components and drives” on page 128.
5. Remove the hard disk drive for easier access to the system fan. See “Replacing the hard disk drive” on
page 132.
138
ThinkCentre E93 Hardware Maintenance Manual