Lenovo 10AQ, Maintenance Manual, Page: 154 / 184

Figure 92. Installing the heat sink fan duct
11. Secure the power supply assembly cables with the cable clips and ties in the chassis.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 169.
Replacing the microprocessor
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and
Setup Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the microprocessor.
To replace the microprocessor, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 126.
3. Lay the computer on its side for easier access to the system board.
4. Locate the system board and disconnect all cables connected to the system board. See “Locating
parts on the system board” on page 80.
150
ThinkCentre E93 Hardware Maintenance Manual