Lenovo 10AQ, Maintenance Manual, Page: 169 / 184

4. Install the Wi-Fi adapter card into one of the two PCI Express x1 slots. Then install the screw to secure
the Wi-Fi adapter card in place.
Figure 113. Installing the Wi-Fi adapter card
5. If the installed Wi-Fi card module supports the Bluetooth function, use a Bluetooth cable to connect the
Bluetooth connector on the Wi-Fi adapter card to the front USB connector on the system board.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 169.
Installing or removing the rear Wi-Fi antenna
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information”
in the
Safety, Warranty, and Setup Guide that came with your computer. To obtain a copy of the Safety, Warranty, and
Setup Guide , go to:
http://www.lenovo.com/support
This section provides instructions on how to install or remove the rear Wi-Fi antenna.
Installing the rear Wi-Fi antenna
To install the rear Wi-Fi antenna, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See “Removing the computer cover” on page 126.
3. Install the rear Wi-Fi antenna to the rear Wi-Fi antenna cable connector attached on the rear of the
computer.
Chapter 10
.
Replacing FRUs (machine type: 10AQ)
165