9. If you want to copy another function in a different mode, simply continue step
4 followed by steps 5, 6 and 7.
10. In step 6, by pressing the [SET] key or Device mode key, you will exit the
learning mode and back to normal operation of RC-8-2.
NOTE :
?During the Learning process, if the LCD shown as ERROR means that the key
was not learned.
?During the Learning process, if the LCD shown as MEM FULL means that the
system memory is full.
Press the [SET] key to for 2 seconds
Press & release the [CH+] key for two (2) times
Press the [SET] key once
Press the [DEVICE] key to select a desired mode, and then press the [SET] key
once
Press the "I
I" key
Press & hold the key that you want to copy
P.6
To delete a learned function : (To delete one single learned function, follow the
steps below.)
Example : to delete the "PIP" function learned on the [I
I] key in TV mode:
1. Press the [SET] key to for 2 seconds and the LCD will be shown CODE
SETUP.
2. Press & release the [CH+] key for two (2) times to view the LEARN MODE
page.
3. Upon the LCD shown as LEARN MODE, press the [SET] key once. The LCD
now shown TV IR LEARN.
4. Press the [CH+] key to the page of delete key and now the LCD shown as
TV DELETE KEY. Press the [Device] key to select a desired mode (TV, VCR,
SAT or AUD, etc..). In this case is [TV] key.
*
Press the [CH-] key once, it did backward to TV IR LEARN page.)
5. Press the [SET] key once and the RC-8-2 LCD shown as TV DELETE KEY
now performed the deleting process. Press the [I
I] key on the RC-8-2 remote
where you want to delete the learned function.
6. After deleting is OK, the LCD shown as SUCEESS.
7. In step 5, by pressing the [SET] key or Device mode key, you will exit the
deleting mode and back to normal operation of RC-8-2.
Press the [SET] key to for 2 seconds
Press & release the [CH+] key for two (2) times
Press the [SET] key once
Press the [CH+] key
Press the [DEVICE] key to select a desired mode, press the [SET] key once and
then press the [I
I] key.