
8. Press the [SET] key once, the LCD shown AUTO TV001 and the RC-8-2
is now performed the auto search count from the code you set up before, for
example TV 001...and so on.
9. If the TV turn off. This indicates that the RC-8-2 is now set to your TV.
10. Press the [SET] key to save the working code. The LCD shown as
SUCCESS and the RC-8-2 is now ready to operate your TV.
11. To check the code, press the [POWER] key to ON position. Press the
[CH+/-], [VOL+/- * * ], *, and other applicable keys. If no function, repeats Steps
1-11.
12. In any cases if you need to leave the auto search, just press the [ESC] key to
exit, the LCD will be shown as EXIT and back to normal operation mode.
13. To program other equipment, repeats the Steps 1-11 for your VCR, SAT,
AUD and or your second TV or VCR or SAT, etc..
Press the [SET] key to for 2 seconds
Press & release the [CH+]
Press the [SET] key once, and than press the [CH+] key once for AUTO
SEARCH
Press the [DEVICE] key to select a desired mode
Press the [SET] key to save the working code
SETTING UP BY QUICK/MANUAL SEARCH
This manual search method checks all its preprogrammed codes to find the code
that will operate your equipment. This method may take a few minutes.
1. Make sure your TV is switched on (not on standby).
2. Aim the RC-8-2 at your TV.
3. Press the [SET] key to for 2 seconds and the LCD will be shown CODE
SETUP.
4. Press & release the [CH+] key once to view the CODE SRCH page.
5. Upon the LCD shown CODE SRCH, press the [SET] key once, the LCD
shown as TV QUICK SRCH. Press the [Device] key to select a desired mode (TV,
VCR, SAT or AUD, etc..). In this case is [TV] key.
6. Press the [SET] key once, the LCD shown as HAND TV001 and the RC-8-2
is now performed the quick/manual search count from the code you set up before,
for example TV 001...and so on.
7. Now, press & release the [CH+] key slowly until the TV turns off. This
indicates that the RC-8-2 is now set to your TV. (During the quick/manual search,
you can press the [CH-] key as backward searching.)
8. Press the [SET] key to save the working code. The LCD shown as
SUCCESS and the RC-8-2 is now ready to operate your TV.
9. To check the code, press the [POWER] key to ON position. Press the
[CH+/-], [VOL+/- * * ], *, and other applicable keys. If no function, repeats Steps
1-9.
10. In any cases if you need to leave the quick/manual search, just press the
[ESC] key to exit, the LCD will be shown as EXIT and back to normal operation
mode.