Attaching the implement
43
Pull the cross shaft (1) out of the holes
completely.
Insert the cross shaft (1) into the re-
quired hole on the shaft plate (5).
Push the cross shaft (1) through the
holes until the ends of the cross shaft (1)
are the same distance from the shaft
plates (5) on both the left and right sides.
Push the locking pieces (4) onto the
cross shaft (1).
Ensure that the end with the support
faces (6) is pointing towards the shaft
plate (5).
Push the locking pieces (4) as far as the
shaft plates (5).
Ensure that the support faces (6) are
touching the stop (7) on the shaft plates
(6).
Tighten the nuts on the bolts (3) to
197 Nm.
1
5
4
1
5
6
7
3
