Attaching the implement
42
Lighting equipment must also be fitted to the implement if it is
necessary to drive on public roads in order to reach the field.
7.2 Cross
shaft
The cross shaft (1) can be mounted on the
implement at two height positions = draw
point settings.
The illustration shows the cross shaft (1) in
the lower mounting position = higher draw
point.
The holes (2) are used to fit the cross shaft
(1) in the upper mounting position = lower
draw point.
Cross shaft mounting
position
Draw point
Function
Top Low
Improve implement entry
Increase roller pressure
Reduce lifting force requirement
Bottom High
Increase lift height
Reduce slip
Reduce roller pressure
With the implement detached from the
tractor, the mounting position of the cross
shaft (1) can be adjusted as follows:
Loosen the nuts on the bolts (3) on both
locking pieces (4).
Pull the cross shaft (1) out of the holes in
the shaft plates (5) as far as the middle.
Push the locking pieces (4) off the cross
shaft (1) and place them on the ground.
1
2
4
5
1
3