Operation
54
9.1.1 Mechanical working depth adjustment
The working depth of the implement can
be adjusted from approx. 7 to 20 cm. Ad-
justment is carried out using the pins (1) in
the hole pattern shown below.
Hole A => shallowest working depth
Hole P => deepest working depth
Lift the implement using the tractor's
three-point linkage until there is no load
on the pin (1).
Release the lower pins (1) by pulling out
the linch pins.
Insert the lower pins (1) into the appro-
priate hole in the adjustment plates (2) to
give the required working depth.
1
P
A
1