Using the IR Remote
The IR remote provides basic camera control.
What do you need to do?
Button(s)
Power on or standby
Power
(green button at top right)
Select the camera to control (if this
remote controls more than one)
Camera Select
buttons 1 through 3
(second row of buttons)
Discover the camera's IP address
Data Screen
button (top left) overlays IP
and MAC addresses on video output. Press
again to dismiss.
Move the camera
Arrow buttons and
Home
button (dark red)
Make left and right arrows behave
intuitively
Std Pan
directions are from the camera's
point of view,
Rev Pan
reverses this.
Move the camera to a preset
position
Position Preset
buttons 1 through 6
(bottom two rows)
Store a preset
Preset
a numbered
Position
Preset
button
Clear a preset
Reset
a numbered
Position
Preset
button
Adjust for excess light behind the
camera's subject
Back Light
button (top center)
Focus the camera
Auto Focus
button (near arrow buttons)
Manual Focus
buttons
Near
and
Far
(below Zoom Speed buttons)
Zoom in (tele) or out (wide)
Zoom Speed
buttons (light gray) - Slow
T
and
W
, Fast
T
and
W
for telephoto (zoom
in) and wide-angle (zoom out) modes
For information about configuring the camera to respond to the remote as camera 1, 2, or 3, see
.
Storing a Preset Using the Remote
Position the camera. Then hold down the Preset button and press one of the numbered preset buttons.
Clearing a Preset Using the Remote
Press and hold the Reset button while pressing the preset number you want to clear.
45
Complete Manual for the RoboFLIP 30 HDBT In-Ceiling HD PTZ Camera