Leader LT4610-SER01, Instruction Manual

Page: 86 / 272

10. GENLOCK MENU
65
10.3.1 Adjusting the Timing (Frame)
To adjust the output signals relative to the reference signal at the frame level, follow the
procedure below.
This menu is displayed in the following situations.
• When the genlock mode is set to GL FMT-AUTO and the format of the signal applied to
GENLOCK IN on the rear panel is NTSC or PAL
• When the genlock mode is set to GL FMT-MANUAL and the format selected in section
10.2, “Selecting the Genlock Format,” is NTSC or PAL
• When the genlock mode is set to GPS and the Black 1 format selected in section 11.1,
“Selecting the Black Format,” is NTSC or PAL
２．ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ Ｆ
０ ＦＲＡＭＥ
Procedure
GENLOCK → TIMING → FRAME
Parameters
NTSC:
-5 to 0 to +5
PAL: -2 to 0 to +2
10.3.2 Adjusting the Timing (Line)
To adjust the output signals relative to the reference signal at the line level, follow the
procedure below.
The variable range varies depending on the format.
２．ＧＥＮＬＯＣＫ ＴＩＭＩＮＧ Ｖ
０ ＬＩＮＥ
Procedure
GENLOCK → TIMING → VERTICAL
Parameters
-1125 to 0 to +1125