Leader LT4610-SER01, Instruction Manual

Page: 24 / 272

4. FEATURES
3
● Ethernet
SNMP is supported. When an error is detected, a TRAP is issued. Further, the LT 4611 can be
controlled through HTTP.
● Preset Memory Function
Up to 10 presets can be saved. Convenient registered presets can be recalled during
operation. The LT 4611 can be started with the same settings every time.
● External Memory Support
Logo data and preset data can be written and saved from the front panel using USB memory
devices.
● Redundant Power Supply
Two power supplies are built in to provide redundancy. When errors occur in power supply
units, alarms are indicated on the LT 4611 panel. Errors can also be output as alarms using
SNMP.
4.2 LT4610-SER01 (GPS/TC)
● GPS Synchronization
A GPS antenna can be connected to generate and output signals by locking to the frequency
and clock obtained from the GPS.
● Time Code I/O
The time code generator can run in free run mode based on internal time information. It can
also embed ATC (LTC) in SDI signal output or VITC in analog video sync signal output based
on a GPS, LTC, or VITC time information.
It also features a holdover function, which retains the phase and frequency of the output
signal when GPS signals or CW signals are lost. Further, when GPS lock is in effect, the LT
4611 can also be used as an NTP server.
● CW I/O
The CW I/O connector not only receives 10 MHz CW but also outputs 10 MHz CW or 1PPS,
whichever is selected.
● LTC I/O
The LTC I/O connector receives LTC1, outputs LTC 3, and outputs two separate alarms.