Leader LT4610-SER01, Instruction Manual

Page: 52 / 272

5. SPECIFICATIONS
31
Component On/Off
Function Each of the Y/G, Cb/B, and Cr/R components can be
turned on and off independently.
On Outputs the specified Y/G, Cb/B, or Cr/R signal
Off
Y/G 040h/000h
Cb/B 200h/000h
Cr/R 200h/000h
* Not available when the check field pattern is selected.
Image Overlay
Display Precedence ID characters > logo mark > safety area markers >
test pattern
(The display order cannot be changed.)
Simultaneous Display ID characters, logo mark, safety area markers, and
test pattern can be displayed simultaneously.
Embedded Audio
Embedded Channels Can be turned on and off at the group level
3G-A, HD, SD 16 channels (4 channels × 4 groups)
3G-B 32 channels (link A, link B, 4 channels each × 4
groups)
Sampling Frequency 48 kHz sampling (synced with the video signal)
Resolution 20 bits, 24 bits
Pre-emphasis OFF, 50/15, CCITT (only the CS bit is switched)
Frequency SILENCE / 400Hz / 800Hz / 1kHz
Level -60 to 0 dBFs (1 dBFs steps)
Audio Click OFF, 1 to 4 sec
* Audio (including packets) cannot be embedded when the check field pattern is selected.
* The frequency, level, and audio click can be set for each channel.
* The following limitations apply for SD (525/59.94I).
• For 16 channel output, the resolution is set to 20 bits.
• Up to three groups (12 channels) can be output at 24-bit resolution.
5.6.4 Lip Sync Patterns
Setting SDI1+AES/EBU and SDI2 can be set separately.
* Not available when the check field pattern is selected.
* Safety area markers, ID characters, and logo mark cannot be overlaid.
* The audio click setting of embedded audio is disabled, and audio synchronized to the lip sync
pattern is output.