LAUNCH KWA-300 3DWireless Wheel Aligner Maintenance
6-1
Maintenance
To prolong the life of the equipment, the user should
maintain it with care. The Wireless Wheel Aligner is of
precision equipment which requires periodical
maintenance.
Computer
z
User should have a basic knowledge about
computer software and hardware to insure the
normal operation of the computer.
z
The main unit and the monitor should be firmly
secured on the desk. Do not put them in a freezing,
wet, extremely hot or direct sunlight place, or near
the source of radiation and heat.
z
Don’t foist anything into the main unit and the
monitor through the gap.
z
Don’t move the computer during operation.
z
Do not switch on/off the computer too frequently.
z
Don’t change the BIOS setting at will.
z
Don’t delete the unknown files in the hard disc at
will to avoid abnormal computer operation or
death.
z
The computer is used only for the Wireless Wheel
Aligner; don’t install other software to the Wireless
Wheel Aligner computer to avoid computer virus.
The computer is scanned to ensure it is free of
virus before leaving factory.
z
Don’t use other software to avoid possible virus.
LAUNCH warranty does not cover the system
problem arising from the virus.
z
After a long period of use, the dust and oil dirt will
be accumulated on the main unit and the monitor.
Please cleanout it with neutral detergent or
dehydrated alcohol. Avoid using oil or caustic
product.
z
Never disassemble the computer and move the
inside cables and cards to avoid damage of the
inside components.
Wheel Clamp and Target
z
The wheel clamp should be cleaned and lubricated
timely to insure that the span of claws can be
easily adjusted and attached.
z
The targets of KWA-300 3D wheel aligner are the
key components for testing, do not damage their
structures when using and storing, keep the
surface of target clean. Please use the soft cloth
dipped with an appropriate amount of the neutral
detergent or the absolute alcohol to wipe the
surface of target lightly if there are some smuts on
it.
z
Don’t disassemble the targets and clamps to avoid
damage of their elements. LAUNCH will not
guarantee for this kind of failure.
Printer
z
Read the operation instruction of the printer
carefully.
z
Install suitable printer drive program, and apply
right printer setting.
z
If the printed words are not clear, it may be that the
ink is used out. Please replace the printer ink
cartridge in time to resume the printing quality.
z
For other printer related problems, please contact
the customer service center.
Posts and Signal Cables
z
There are two precision CCD cameras inside the
posts. The precision position calibration has been
performed for the cameras after first installation.
The user can not move or wobble the camera post
no matter during or after using it.
z
Since computer visual technology is used to
recognize the targets mounted on the wheels
through the camera with high resolution, it is
necessary for KWA-300 3D to prevent the outside
infrared rays (e.g. sun-lights) from directly lighting
to the targets and reflecting to the cameras, and it
is necessary to avoid blocking the light way from
the targets and the cameras for a long time during
the instrument is working.
z
The wires inside the cabinet and the camera posts
are connected compactly. Don’t move them after
first installation.
z
Without approval of the supplier, please do not
disassemble the main unit and camera post in
order to avoid damaging the components,
influencing the test accuracy and increasing the
costs and difficulties of maintenance and repair.
For the damage caused by unauthorized
disassembling will not be covered by the Warranty.
Turntables
The electronic turntables are precision components.
Avoid hitting during operation and never splash water on
them.
When moving the vehicle on the turntable, please insert
the locking pin to avoid the turntable sliding.
Generally speaking, it is not necessary to lubricate the
turntables frequently.
Summary of Contents for KWA-300
Page 1: ......
