Launch KWA-300, User Manual

Page: 22 / 34

LAUNCH KWA-300 3D Wheel Aligner Operation Instructions
4-7
Click pushbutton to select the parameters of
standard vehicle model. If the parameter values of
wheelbase and front/rear track width are contained in
the standard database, each angle value displayed on
the screen will automatically be converted into length
value with the unit of mm. The interface is as shown in
Fig.4.22.
Fig.4.22
Note: The system provides the dynamic
measurement and display for these special values,
but the measurement result will not be saved in the
database.
[HELP for vehicle adjustment]: Click this button, the
screen will pop up an interface of [HELP for vehicle
adjustment], the different toe-in and camber adjusting
methods for various vehicle models have been
enumerated in this interface for vehicle adjustment, the
operator can perform the toe-in and camber adjustment
operation according to the operating methods in the
HELP interface. The interface is as shown in Fig.4.23.
Fig.4.23
[Lift up the vehicle body]: Sometimes it is required to lift
the vehicle body up in order to be convenient to adjust
front/rear camber and caster. The system can provide
Lift-up adjustment function. When the vehicle body is
lifted up, the measured data can be displayed normally
on the interface, and user may adjust the alignment
geometry according to the prompts on the interface.
Fig.4.24
Attention: After adjustment, please remember to
click button, and then put down the vehicle
body according to the prompts on the screen. If the
lift is not put down, it will be limited to select the
other interfaces (except for [Front axle measurement]
interface) as shown in Fig.4.25.
Fig.4.25
Front axle measurement
This interface can provide the real-time result related to
front axle measurement, the operator can compare the
measurement result with the reference data while
adjusting the vehicle, until the vehicle is adjusted to the
best status. The interface is as shown in Fig.4.26.