Lantronix
SISPM1040-582-LRT CLI Reference
33757 Rev. J
Page
125
of
272
no Commands (Interface Config Mode)
access-list
Access list
aggregation Aggregation keyword
debug Debugging functions
description
To clear port description
dot1x IEEE Standard for port-based Network Access Control
duplex Set duplex to default.
excessive-restart
Restart backoff algorithm after 16 collisions (No excessive-restart means discard
frame after 16 collisions)
flowcontrol Configure flow control.
frame-length-check
Do not drop frames with mismatch between EtherType/Length field and actually
payload size.
green-ethernet Green ethernet (Power reduction)
gvrp Enable GVRP on interface or interfaces
ip Internet Protocol
ipv6 IPv6 configuration commands
lacp Enable LACP on this interface
link-oam Enable or Disable (when the no keyword is entered) Link OAM on the interface
lldp LLDP configurations.
loop-protect
Loop protection configuration on port
mac MAC keyword
mtu Maximum transmission unit
mvr Multicast VLAN Registration configuration
poe Power Over Ethernet.
port-security
Enable/disable port security per interface.
ptp Disable PTP for the interface(s)
pvlan Private VLAN
qos Quality of Service
rmon Configure Remote Monitoring on an interface
sflow Statistics flow.
shutdown Shutdown of the interface.
spanning-tree Enable/disable STP on this interface
speed Configure speed to default.
switchport Switching mode characteristics
udld Disable UDLD
Example
:
SISPM1040-582-LRT(config-if)#
no flowcontrol
SISPM1040-582-LRT(config-if)#
no excessive-restart
SISPM1040-582-LRT(config-if)#
no duplex ?
<cr>
SISPM1040-582-LRT(config-if)#
no duplex
E port/conf 04:08:53 149/vtss_appl_port_conf_set#4937: Error: SFP ports only sup
ports full aneg (port_no 8)
E port/conf 04:08:54 149/vtss_appl_port_conf_set#4937: Error: SFP ports only sup
ports full aneg (port_no 9)
Illegal advertise disabling for current mode
SISPM1040-582-LRT(config-if)#
SISPM1040-582-LRT(config-if)#
no debug ?
phy Select phy for debugging (Note only local PHYs, NOT stack-aware)
SISPM1040-582-LRT(config-if)#
no debug phy ?
loopback Enable/Disable loopback in the PHY
SISPM1040-582-LRT(config-if)#
no debug phy loopback ?
far Far end loopback (Cu port)
