Set/Define Protocols Commands
Command Reference
12-30
Parameters
TCPKeepalive
Controls whether the Server will send TCP keepalive messages. It is enabled
by default, and should remain enabled unless you are absolutely sure you want
to disable it.
Timeserver
Controls whether the Server will send IP daytime request packets. It is enabled
by default.
See Also
Set/Define Server IPaddress, page 12-40; Set/Define Server Gateway, page 12-
37; Set/Define Server Loadhost, page 12-41; TCP/IP Server Parameters, page
4-5; Installation Guide.
12.27.3 Define Protocols LAN Manager
Enables or Disables the LAN Manager protocol.
Applies To
EPS1, EPS2, EPS2-100, EPS4-100, MPS1, MPS100
Restrictions
You must be the privileged user to use this command.
See Also
LAN Manager, page 2-3.
12.27.4 Set/Define Protocols LAT
Enables or Disables the LAT protocol, and allows the Server administrator to enter the string needed to
enable LAT functionality. The license number must be entered before any LAT functionality is available.
Applies To
EPS1, EPS2, EPS2-100, EPS4-100, MPS1, MPS100
Restrictions
You must be the privileged user to use this command.
Errors
Enabled/Disabled parameters must be defined.
LicenseString is not needed for single-port servers.
Parameters
LicenseString
The license string, used to enable LAT functionality on the unit, can be
obtained by calling Lantronix.
DEFINE PROTOCOLS LANMAN
ENABLED
DISABLED
SET
DEFINE
PROTOCOLS LAT
ENABLED
DISABLED
LicenseString