817-5258-11
1
Replacing the Sun Fire v20z or Sun Fire V40z Cable Kit
This document contains:
■
“Replacing a Cable Kit in a Sun Fire V20z Server” on page
■
“Replacing a Cable Kit in a Sun Fire V40z Server” on page
Replacing a Cable Kit in a Sun Fire V20z Server
Follow these steps to remove and replace the following cables (refer to
):
■
Five-pin cable connecting the SCSI backplane to the motherboard (1).
■
68-pin ribbon cable connecting the SCSI backplane to the motherboard (2).
■
Flat cable connecting the SCSI backplane to the motherboard (3).
■
Flat cable connecting the CD-ROM/DVD to the motherboard (5).
■
Flat cable connecting the Diskette Drive to the motherboard (6).
■
Flat cable connecting the operator panel board to the motherboard (7).
1. Turn off the system, including any attached peripherals.
Refer to the
Sun Fire V20z and Sun Fire V40z Servers User Guide
for full instructions
on powering off the server.
2. While pressing the cover latch release button with your right thumb (A),
slide the
cover towards the rear of the chassis until it contacts the stop (B).
3. Lift the cover up and remove it.
FIGURE
1
Removing the Sun Fire V20z Cover
A
B
