7: Services
SLB™ Branch Office Manager User Guide
86
Audit Log
SMTP
SSH
Network Level
Messages concerning the network activity, for example about Ethernet and routing.
Services
Messages concerning services such as SNMP and SMTP.
Authentication
Messages concerning user authentication.
Device Ports
Messages concerning device ports and connections.
Diagnostics
Messages concerning system status and problems.
General
Any message not in the categories above.
Remote Servers
(#1 and #2)
IP address of the remote server(s) where system logs are stored.
The system log is always saved to local SLB storage. It is retained through SLB branch
office manager reboots for files up to 200K. Saving the system log to a server that
supports remote logging services (see RFC 3164) allows the administrator to save the
complete system log history.
Enable Log
Select to save a history of all configuration changes in a circular log. Disabled by
default. The audit log is saved through SLB reboots.
Size
The log has a default maximum size of 50 Kbytes (approximately 500 entries). You
can set the maximum size of the log from 1 to 500 Kbytes.
Include CLI
Commands
Select to cause the audit log to include the CLI commands that have been executed.
Disabled by default.
Include In System
Log
If enabled, the contents of the audit log are added to the system log (under the
General/Info category/level). Disabled by default.
Server
IP address of your network’s Simple Mail Transfer Protocol (SMTP) relay server.
Sender
The email address of the sender of outgoing emails. The strings "$host" and "$domain"
can be part of the email address - they will be substituted with the actual hostname and
domain. The default is donotreply@$host.$domain.
Enable Logins
Enables or disables SSH logins to the SLB branch office manager to allow users to
access the CLI using SSH. Enabled by default.
This setting does not control SSH access to individual device ports. (See
for information on enabling SSH access to individual ports.)
Most system administrators enable SSH logins, which is the preferred method of
accessing the system.
Web SSH
Enables or disables the ability to access the SLB command Iine interface or device
ports (connect direct) through the Web SSH window. Disabled by default.
Timeout
If you enable SSH logins, you can cause an idle connection to disconnect after a
specified number of minutes. Select
Yes
and enter a value of from 1 to 30 minutes.
Note:
You must reboot the unit before a change will take effect.
SSH Port
Allows you to change the SSH login port to a different value in the range of 1 - 65535.
The default is 22.
Note:
You must reboot the unit before a change will take effect.
Summary of Contents for 100-120 VAC SLB
Page 114: ...8 Device Ports SLB Branch Office Manager User Guide 114 Figure 8 4 Device Ports Settings ...
Page 131: ...8 Device Ports SLB Branch Office Manager User Guide 131 Figure 8 10 Devices Power Outlets ...
Page 174: ...9 USB Port SLB Branch Office Manager User Guide 174 Figure 9 3 Devices USB Modem ...