8: Device Ports
SLB™ Branch Office Manager User Guide
167
3. Click the
Add Site
button.
To view or update a site:
1. In the
Sites
table, select the site and click the
View Site
button. The site attributes are
displayed in the bottom half of the page.
2. Update any of the site attributes.
3. Click the
Edit Site
button.
To delete a site:
1. Select the site in the
Sites
table.
2. Click the
Delete Site
button.
Configures a set of site-oriented modem parameters that can be activated by various modem-
related events (authentication, outbound network traffic for DOD connections, etc.).
The site parameters will override any parameters configuredfor the modem.
Uses sites with a modem, enable 'usesites'. Sites can be used with the following modem states:
dialin, dialback, cbcpserver, dialondemand, ondemand, and dondemand.
Site Commands
Go to
to view CLI commands which correspond to the web page
entries described above.
Modem Dialing States
This section describes the modem states and the options that are used for each modem state. For
a description of modem states that can be used with sites, see
Dial-In
The SLB unit waits for a peer to call the SLB device to establish a text (command line) or PPP
connection.
For text connections, the user will be prompted for a login and password, and will be
authenticated via the currently enabled authentication methods (Local Users, NIS, LDAP, etc).
Once authenticated, a CLI session will be initiated, and the user will remain connected to the
Dial-back Retries
For dial-back and CBCP Server, the number of times the SLB unit will retry the dial-
out portion of the dialing sequence if the first attempt to dial-out fails.
Modem Timeout
Timeout for dial-in and dial-on-demand PPP connections. Select
Yes
(default) for the
SLB device to terminate the connection if no traffic is received during the configured
idle time. Enter a value of from 1 to 9999 seconds. The default is 30 seconds.
Restart Delay
The number of seconds after the modem timeout and before the SLB branch office
manager attempts another connection. The default is 30 seconds.
CBCP Server
Allow No Callback
For a CBCP Server site, allows "No Callback" as an option in the CBCP handshake in
addition to User-defined Number and Admin-defined Number.
Enable NAT
Select to enable Network Address Translation (NAT) for PPP connections.
Note:
IP forwarding must be enabled on the Network - Settings page for NAT to work.
Summary of Contents for 100-120 VAC SLB
Page 114: ...8 Device Ports SLB Branch Office Manager User Guide 114 Figure 8 4 Device Ports Settings ...
Page 131: ...8 Device Ports SLB Branch Office Manager User Guide 131 Figure 8 10 Devices Power Outlets ...
Page 174: ...9 USB Port SLB Branch Office Manager User Guide 174 Figure 9 3 Devices USB Modem ...