11: User Authentication
SLB™ Branch Office Manager User Guide
200
Encrypt Messages
Select
Start TLS
or
SSL
to encrypt messages between the SLB unit and the LDAP
server. If
Start TLS
is selected, the port will automatically be set to 389 and the
StartTLS extension will be used to initiate a secure connection; if
SSL
is selected,
the port will automatically be set to 636 and a SSL tunnel will be used for LDAP
communication. The port number can be changed to a non-standard LDAP port; if
the port number is set to anything other than 636, Start TLS will be used as the
encryption method. Disabled by default.
A certificate can be uploaded to the SLB unit for peer authentication. The certificate
file is a file of CA certificates in PEM format. The file can contain several CA
certificates identified by:
-----BEGIN CERTIFICATE-----
(CA certificate in base64 encoding)
-----END CERTIFICATE-----
sequences. Before, between, and after the certificates text is allowed which can be
used e.g. for descriptions of the certificates.
Certificate
Click the
Upload File
link to upload a certificate file to the SLB unit for peer
authentication. The certificate file is a file of CA certificates in PEM format. The file
can contain several CA certificates identified by:
-----BEGIN CERTIFICATE-----
(CA certificate in base64 encoding)
-----END CERTIFICATE-----
sequences. Before, between, and after the certificates text is allowed which can be
used e.g. for descriptions of the certificates.
Custom Menu
If custom menus have been created, you can assign a default custom menu to
LDAP users. (
)
Escape Sequence
A single character or a two-character sequence that causes the SLB branch office
manager to leave direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is
Esc+A
(escape key, then uppercase "A" performed quickly
but not simultaneously). You would specify this value as
\
x1bA
, which is
hexadecimal (
\
x
) character 27 (
1B
) followed by an
A
.
This setting allows the user to terminate the
connect direct
command on the
command line interface when the endpoint of the command is deviceport, tcp, or
udp.
Break Sequence
A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is
Esc+B
(escape key,
then uppercase “B” performed quickly but not simultaneously). You would specify
this value as
\
x1bB
, which is hexadecimal (
\
x
) character 27 (
1B
) followed by a
B
.
Enable for Dial-back
Select to grant a user dial-back access. Users with dial-back access can dial into
the SLB unit and enter their login and password. Once the SLB device
authenticates them, the modem hangs up and dials them back. Disabled by default.
DIal-back Number
The phone number the modem dials back on depends on this setting for the device
port. The user is either dialed back on a fixed number, or on a number that is
associated with the user’s login (specified here).
Data Ports
The ports users are able to monitor and interact with using the
connect
direct
command.
Listen Port
The ports users are able to monitor using the
connect listen
command.
Clear Port Buffers
The ports whose port buffer users may clear using the
set locallog clear
command.
Access Outlets
The outlets the user may monitor and configure.
Summary of Contents for 100-120 VAC SLB
Page 114: ...8 Device Ports SLB Branch Office Manager User Guide 114 Figure 8 4 Device Ports Settings ...
Page 131: ...8 Device Ports SLB Branch Office Manager User Guide 131 Figure 8 10 Devices Power Outlets ...
Page 174: ...9 USB Port SLB Branch Office Manager User Guide 174 Figure 9 3 Devices USB Modem ...