- 51 / 79 -
LANGER
EMV-Technik
DE-01728 Bannewitz
[email protected]
www.langer-emv.de
FLS 106 IC set / FLS 106 PCB set
8. When installation is complete, you can decide whether to start the software immediately or
not by ticking the appropriate checkbox.
9. Click "Finish".
Putting the FLS 106 Scanner into Service with the
15.3
ChipScan-Scanner Software
Ensure that the system has been set up as described in chapter 13 (item a
– m) and the driver
described in section 15.1 has been installed.
The ChipScan-Scanner software user manual with additional information on the individual steps
can be accessed if the software is open via the "Manual" entry in the "Help" menu.
The scanner and the PC must be switched on and connected via a USB 2.0 cable.
The following steps have to be carried out to check whether the FLS 106 scanner functions
properly:
1. Start the ChipScan-Scanner software.
2. Connect the ChipScan-Scanner software to the FLS 106 scanner:
-
Click the "Device Manager…" entry in the "Devices" menu in the ChipScan-Scanner
software.
- Click the "Detect Devices" button.
- Searching for the connected devices takes some time. The following entries should then
appear in the "Identified devices used for measurement" section:
o
In the "Video Device" selection box ->
Name of the connected camera
o
In "Scanner" selection box ->
Name of the connected scanner
o
In the "Spectrum Analyzer" selection box ->
Name of the connected spectrum
analyzer
- Optional steps to speed up the device identification:
In the open "Device Manager" window:
o
Select the COM interface to which the scanner is connected in the "RS232"
selection box in the "Scanner" section.
o
Select the "Langer FLS 106" entry in the selection box below "RS232".
o
Then click the "Detect Devices" button.
- After a successful search, close the "Device Manager" by clicking the cross in the upper
right corner.
- Please refer to chapter 4 in the ChipScan-Scanner software user manual for further
information.
