Lancia Ypsilon, Owner'S Handbook Manual

Page: 26 / 222

25
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
WARNING
LIGHTS AND
MESSAGES
IN AN
EMERGENCY
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
Instrument panel and sound
system/automatic climate control
light dimmer (Light.)
(only with sidelights on)
With this function it is possible to ad-
just on 8 levels (with sidelights on) the
light intensity of the instrument panel,
sound system controls and automatic
climate control (where provided) con-
trols.
To adjust the light intensity level re-
quired, proceed as follows:
– briefly press button MODE the pre-
viously set level will flash on the dis-
play;
– press button
ö
or
õ
to select the re-
quired level;
– briefly press button MODE to go
back to the menu screen or press the
button for long to go back to the stan-
dard screen without storing settings.
Speed limit (Speed lim.)
With this function it is possible to set
the car speed limit (km/h or mph);
when this limit is exceeded the driver
is immediately alerted (see section
“Warning lights and messages”).
To set the speed limit, proceed as fol-
lows:
– briefly press button MODE , the dis-
play will show the wording (Speed
lim.);
– press button
ö
or
õ
to select speed
limit activation (On) or deactivation
(Off);
– after pressing (On), press button
ö
or
õ
to select the required speed limit
value and then press MODE to con-
firm.
Note The possible setting is between
30 and 250 km/h, or between 20 and
155 mph depending on the unit set
previously (see “Distance unit (Dist.
unit)” paragraph described later.
Every press on button
ö
/
õ
in-
creases/decreases by 5 units. Keeping
the button
ö
/
õ
pressed obtains the
fast automatic increase or decrease.
When you are near the required set-
ting complete adjustment by single
presses.
briefly press button MODE to go back
to the menu screen or press the but-
ton for long to go back to the stan-
dard screen without storing settings.
To abort the setting, proceed as fol-
lows:
– briefly press button MODE , (On)
will flash on the display;
– press button
õ
, (Off) will flash on
the display;
– briefly press button MODE to go
back to the menu screen or press the
button for long to go back to the stan-
dard screen without storing settings.
Automatic headlight daylight
sensor (Light sensor)
(where provided)
With this function it is possible to ad-
just the light sensor sensitivity ac-
cording to 3 levels (level 1 = min.
level, level 2 = average level, level 3 =
max. level); the higher the sensitivity
is, the lower is the external light in-
tensity required to switch on the
lights. The car is delivered with sen-
sitivity level “2”.
To set the light level required, proceed
as follows:
– briefly press button MODE , the pre-
viously set level will flash on the dis-
play;
– press button
ö
or
õ
to select the re-
quired level;
– briefly press button MODE to go
back to the menu screen or press the
button for long to go back to the stan-
dard screen without storing settings.
001-034 Ypsilon GB 10-10-2008 10:17 Pagina 25