Lancia Ypsilon, Owner'S Handbook Manual

Page: 183 / 222

182
WARNING
LIGHTS AND
MESSAGES
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
CAR
MAINTENANCE
Changing the windscreen wiper
blades fig. 15
Proceed as follows:
❒
raise the windscreen wiper arm A
and position the blade so that it
forms an angle of 90° with the arm;
❒
press tab B of the coupling spring
and remove the blade ;
❒
fit the new blade by inserting the
tab into the special slot in the arm.
Make sure it is properly locked into
place.
Changing the rear window blade
fig. 16
Proceed as follows:
❒
raise the cover A and remove the
arm from the car, slackening the
nut B that fastens it to the pivot
pin;
❒
fit the new arm, positioning it cor-
rectly, and fully tighten the nut;
❒
lower the cover.
SPRAY NOZZLES
Windscreen wiper
If the jet of fluid is inadequate, firstly
check that there is fluid in the reser-
voir: see “Checking fluid levels” in
this section).
Then check that the nozzle holes are
not clogged, if necessary use a needle.
Fluid jets shall be directed at about
1/3 height from the window upper
edge.
Rear window wiper
Rear window washer jets can be ad-
justed in the same way.
The nozzle holder is located on the
left side of the third brake light unit.
fig. 16 L0C0095m fig. 15 L0C0094m
165-186 Ypsilon GB 10-10-2008 11:22 Pagina 182