Lancia Ypsilon, Owner'S Handbook Manual

Page: 148 / 222

147
WARNING
LIGHTS AND
MESSAGES
CAR
MAINTENANCE
TECHNICAL
SPECIFICATIONS
INDEX
DASHBOARD
AND CONTROLS
SAFETY
DEVICES
CORRECT
USE OF
THE CAR
IN AN
EMERGENCY
For versions with alloy rims
❒
Make sure that hub contact sur-
faces are clean;
❒
Refit the standard wheel fitting it
on the pins, refit the fastening bolts
and tighten them using the wrench
provided;
❒
Lower the car and remove the jack;
❒
Using the wrench provided, fully
tighten the bolts in the sequence
shown previously for the spare
wheel (see the figure).
When you have finished
❒
Stow the spare wheel C-fig. 15 in
the space provided in the boot;
❒
Insert the partially open jack into
the container B-fig. 15 and force it
slightly into its seat so that it does
not vibrate when the car is moving;
❒
Put the tools back into their places
in the container;
❒
Stow the container complete with
tools on the spare wheel and secure
everything with the clamping de-
vice A-fig. 15 ;
❒
Correctly reposition the boot stiff
cover.
WHEN NEEDING
TO CHANGE A
BULB
GENERAL INSTRUCTIONS
❒
When a light is not working, check
that the corresponding fuse is intact
before changing a bulb. For the loca-
tion of fuses, refer to the paragraph
“If a fuse blows” in this chapter.
❒
Before changing a bulb check the
contacts for oxidation;
❒
Burnt bulbs must be replaced by oth-
ers of the same type and power;
❒
Always check the height of the head-
light beam after changing a bulb.
fig. 15 L0C0114m
Halogen bulbs must be
handled touching only the
metallic part. If the trans-
parent bulb is touched with
the fingers, its lighting intensity is
reduced and life of the bulb may be
compromised. If touched acciden-
tally, rub the bulb with a cloth
moistened with alcohol and leave it
to dry.
135-164 Ypsilon GB 13-10-2008 11:42 Pagina 147