lancer 85-3151R-VV, Operation Manual

Page: 8 / 36

1. INSTALLATION
1.1 UNPACKING THE DISPENSER
A. The Lancer dispenser is shipped in a corrugated shipping carton.
B. Remove dispenser from corrugated shipping carton.
C. Inspect unit and parts for concealed damage. If damage exists, notify delivering carrier and file
claim against the carrier.
1.2 SELECTING A LOCATION
A. Select a counter location which is near a properly grounded electrical outlet, and a water supply
that meets the requirements specified in Section 1.6.
B. Unit is designed to be supported by remote chiller system or remote ice cooled system. See the
manufacturer’s specifications for installation.
1.3 ADA STANDARDS FOR ACCESSIBLE DESIGN
To assure that beverage service is accessible to all
customers, Lancer recommends that counter height and
equipment selection be planned carefully. The 2010 ADA
Standards for Accessible Design states that the maximum
reach height from the floor should be no more than 48” if
touch point is less than 10” from the front of the counter,
or a maximum of 46” if the touch point is more than 10”
and less than 27” from the front of the counter
(See Fig 1).
For more information about the customer’s legal
requirements for the accessibility of installed equipment,
refer to 2010 ADA Standards for Accessible Design -
http://www.ada.gov.
8
1.4 INSTALLATION OF THE UNIT
A. DRIP TRAY INSTALL
1. Inspect the counter location where the unit is to be installed. Verify the selected counter is
strong enough to safely support the weight of the installed unit, after the cutout for the unit
is made.
2. Use the Counter Cutout template provided in the Install Kit for correct dimensions.
NOTE:
The ideal counter for installation should measure at least 1” thick.
3. Cut the required holes as shown on the Counter Cutout for the Drip Tray and Font Shank.
4. Place Drip Tray in the counter.
Figure 1