lancer 85-3151R-VV, Operation Manual

Page: 10 / 36

10
C. JUNCTION BOX INSTALLATION
NOTE:
The Font Ribbon Cable, Harness, Syrup and Water lines are 36” inches length. Placement
of Junction Box must be under counter within 2’ of Font/Drip Tray Assembly. The Junction Box
slides on the hanging bracket to expose
components (Fig 4). It is recommended that the Junction Box is mounted with the inlet fittings fac-
ing the rear so the access panel can swing down to access the Box interior.
1. Position the Mounting Bracket to ensure adequate slack remains for
connection lines to accommodate sliding the Box forward for servicing.
2. Secure the Mounting Bracket to bottom of counter with four screws (Fig 5).
3. Align the Junction Box flanges with Bracket Guides, slide Box under counter
(Fig 6).
Figure 4
Mounting
Bracket
Junction
Box
Figure 5
Figure 6
F
WARNING
DO NOT INSTALL OR SET THE JUNCTION BOX ON THE GROUND. THIS IS A SHOCK HAZARD.
ADVERTENCIA ELÉCTRICA
NO INSTALAR O CONFIGURAR LA CAJA DE EMPALME EN EL SUELO. SE TRATA
DE UN RIESGO DE DESCARGA ELÉCTRICA.
AVERTISSEMENT ÉLECTRIQUE
NE PAS INSTALLER OU CONFIGURER LA BOÎTE DE JONCTION SUR LE TER-
RAIN. IL S’AGIT D’UN RISQUE DE CHOC ÉLECTRIQUE.