lancer 85-3151R-VV, Operation Manual

Page: 19 / 36

19
Figure 15. VV Programmer
Figure 16. Selecter Board
Figure 17. Toggles Shown in
Position to Corresponding Valve
Figure 17. Main Board
Connect to
VV Programmer
Toggle
Connect to
Main Board
5.1 PROGRAMMING wITH THE VOLUMETRIC HANDHELD PROGRAMMER
NOTE:
REQUIRES VOLUMETRIC HANDHELD PROGRAMMER AND SELECTOR BOARD
(PN 64-5050) PROGRAMMER IS SOLD SEPARATELY FOR VV PROGRAMMING ONLY)
(C = CARBONATED; 5.00 = 5:1 RATIO)
A. Connect the Volumetric Handheld programmer (Fig 15) to
J2 on the Selector Board (Fig 16).
B. Connect the Selector Board Cable to the J8 on the Main
Board.
C. Select the valve for programming by adjusting the toggle
for the selected valve as shown in Fig 17.
D. Press [red mem] to read the valve ratio setting in
memory.
E. Press [carb toggle] button to choose between carbonated
(C) or non-carbonated rink (n).
F. Press [+] or [-] to raise or lower desired ratio.
G. Press ‘enter’ button to save the setting into the valve
memory.
AFTER PROGRAMMING IS COMPLETE
5.2 CONFIGURATION
A. SW 1 ON THE MAIN BOARD
NOTE: Fig 18 displays all toggles are switched to ‘OFF’ mode for illustrative purposes.
1. Any changes to SW1 will cause the dispenser to reset.
2. Leave Toggle 1 in ‘OFF” position for LFCV Mode.
3. Switch Toggle 1 to ‘ON’ for Volumetric Mode.
4. If Toggle 2 is switched to ‘ON’, pressing a brand button in IDLE MODE will dispense
product.
5. Volumetric Mode Only: during a water manual dispense, if the volume of product dispensed
reaches 128oz, the water LED turns off and dispense stops.
B. IDLE MODE
This is the normal operating mode of the dispenser. At the start of IDLE MODE, the mode
LED is turned off.
1. Active brand is indicated by the illuminated LEDs. (ON - active/ OFF - not active).
Only one brand can be Active at a time.