55
Instructions and Installation
• Rear surface of the oven gets
hot when it is in use. Make sure
that the electrical connection
does not come into contact
with the rear surface otherwise,
connections can get damaged.
• The connection cable must not
be clamped,bent or trapped
or come into contact with hot
parts of the oven. You may
cause the oven to short circuit
and catch fire as a result of
the cable melting. If the power
cord is damaged, it must
be replaced by a qualified
electrician. Otherwise there is
a risk of an electric shock, short
circuit or fire!
• The plug of the power cord
should be easily accessible
after installation (but not over
the hobs).
• When wiring, you must comply
with national / local electrical
regulations and use socket
outlet / line and plug suitable
for the Oven. If the power limits
of the product exceed the
current carrying capacity of the
plug and socket outlet / line,
you must connect the product
directly to the fixed electrical
installation without using the
plug and socket outlet / line.
• Make sure that fuse rating is
compatible with the product.
• Connection must comply with
national regulations.
• The mains supply data must
correspond to the data
specified on the type label of
the product. Open the front
door to see the type label.
• Power cable of your product
must comply with the values in
“Technical specifications” table.
If the product will be connected
directly to the supply power:
• If it is not possible to disconnect
all poles in the supply power, a
disconnection unit with at least
3 mm contact clearance (fuses,
line safety switches, contractors)
must be connected and all
the poles of this disconnection
unit must be adjacent to
(not above) the product in
accordance with IEE directives.
Failure to obey this instruction
may cause operational
problems and invalidate the
product warranty.
• Additional protection by a
residual current circuit breaker
is recommended.
If the product is produced
with cable and plug
• Your product is produced with
mains cable and plug. Connect
the plug of your product to a
grounded outlet and make the
electrical connection.
If the product is produced
with cable and without plug
• Connect the cord of the
product to supply power
as identified below:
BROWN
cable
=
L
(Phase)
BLUE
cable =
N
(Neutral)
GREEN
/
YELLOW
cable = (
E
)
(Ground)
