Laguna Tools MSANWB25X60-1K-7.5-0197, Manual

Page: 31 / 62

31
2. Turn the conveyor on.
3. If the conveyor is running to the right, turn the right-hand adjusting screw clockwise.
Only make very small adjustments and wait for the conveyor to settle before making
additional adjustments. It is better to take your time and not rush the adjustments.
4. If the conveyor is running to the left, turn the left-hand adjusting screw clockwise.
5. Once the conveyor is running centrally, stop the conveyor and replace the steel
cover.
Conveyor tensioning
To increase the tension on the conveyor belt, turn the adjusting bolts clockwise. To
reduce the tension on the conveyor belt, turn the adjusting bolts counter-clockwise.
Note. Adjust both adjusting bolts exactly the same amount, or the tracking will be
affected.
Motor drive belt adjustment
Lock nut Break
Sanding head drive motor
Adjusting nut
Lock nut
Conveyor vertical drive motor
Sanding head drive motor belt adjustment
The sanding head drive motor has a break that is activated when the power is removed
from the motor. The break is air activated and should not need any regular servicing.
The drive belts will need to be adjusted from time to time. To adjust, loosen the lock nut
and turn the adjusting nut (under bracket) until the correct tension is achieved. Do not
forget to re-tighten the lock nut after the adjusting has been completed.
Note. Never access the motor with the power connected to the sander.