Laguna Tools MSANWB25X60-1K-7.5-0197, Manual

Page: 29 / 62

29
Ceramic rollers The ceramic rollers must be checked regularly for wear, cracks and
general damage. Two spares are supplied.
Platen graphite pad
The sanding belt runs on a
graphite pad that is backed
by a felt pad. The graphite
will wear out eventually. A
spare graphite pad is
supplied with the sander.
Replace the graphite or the
felt pad as follows.
1. Remove the clamp and
screw as detailed earlier.
2. Using the extraction tool,
pull the platen out from the
sander.
3. To replace the graphite
pad, remove the fixing
screws, remove the old
graphite pad, replace the
graphite pad and replace the
screws.
4. To replace the felt pad, remove the old felt pad. Using a small amount of contact
adhesive, attach the new felt pad to the platen.
5. Replace the platen into the sanding machine.
Note. Ensure that the graphite pad is facing the correct way with the screws to the left-
hand side.
Pressure roller adjustment
There are two pressure rollers: one on
the in-feed side and the other on the out-
feed side of the sanding rollers. The
pressure rollers come factory set but
may need to be adjusted during the life
of the machine.
Adjust the rollers as follows.
1. Place a panel on the bed of the
sander so that it is under both the in-
feed and out-feed rollers.
2. Set the bed of the sander vertically so
that one of the pressure rollers ju
Platen
Extraction tool
Fixing screws
Graphite pad
Felt pad
Pressure roller adjusting screws
.