Laguna Tools MSANWB25X60-1K-7.5-0197, Manual

Page: 17 / 62

17
Fitting the sanding belt
Note. Disconnect the sander from the electrical supply.
Clamp Spacer
Roller tension switch
Sanding belt direction arrow
1. Rotate the roller tension switch counter-clockwise to lower the tension roller.
2. Rotate the clamp counter-clockwise and lift out.
Note. The clamp is a quick release and needs only to be rotated approximately 90
degrees to release.
3. Remove the spacer. This will allow access for the sanding belt.
4. Slide the sanding belt onto the top and bottom rollers.
Note. Ensure that the direction arrows on the inside of the sanding belt are facing in the
correct direction (counter-clockwise). If the belt is assembled with the arrows in the
incorrect direction,
the belt will break .
5. Replace the spacer and clamp.
6. Rotate the roller tension switch clockwise to raise tension roller.