Laguna Tools MSANWB25X60-1K-7.5-0197, Manual

Page: 30 / 62

30
3. Loosen the lock nuts and adjust the pressure rollers so that they are both just
touching the panel. This must be completed at the extremities of the rollers to ensure
that they are parallel.
4. With the rollers parallel, adjust the rollers to the required setting and lock the lock
nuts.
Note. When adjusting the height of the pressure rollers, after ensuring that they are
parallel, adjust each screw the same amount or the rollers will not be parallel.
Note. Adjusting the pressure rollers must be done with the sanding belt stationary.
Note. The amount of pressure that you set the pressure rollers to exert on the job will
vary depending on such variables as the depth of cut, hardness of the wood and other
factors. Experimentation will be required to achieve the correct setting. It is suggested
that setting the pressure rollers to 0.020" to 0.030" is a good starting point. Never set
the pressure rollers level or higher than the sanding rollers, as this may result in injury.
Adjusting the conveyor belt
Conveyor belt adjusting bolt
The conveyor belt comes factory set but may need
to be adjusted at some time.
The conveyor belt must run centrally on the rollers
and must be tensioned to prevent slippage. If the
belt is not running centrally, check that the tension
is correct before adjusting the tracking. Adjust as
follows.
Conveyor tracking adjustment
1. You may find it easer to remove the steel cover
to expose the two guide wheels. To achieve this, remove the fixing screws.