Labrie Automizer Versa Hand, Maintenance Manual

Page: 168 / 190

160 Programming
Figure 9-1
START CYCLE
button (green) and
MULTI CYLE
switch
The number of cycles needs to be adjusted depending on the type of collection route used by the
vehicle. For example, in a residential area, if the houses are numerous and close one to another, it may
be required to increase the number of cycles. This will allow the hopper to be clear for the next house
pickup.
Each time the packer completes a full cycle, the proximity switch located on the right-hand side,
behind the packer, sends a signal to the IFM electronic control module. This module counts the
amount of cycles that the packer does. The IFM module will stop the packer after the preset amount
of cycles has been reached.
To change the preset amount of cycles:
1.
In the vehicle cab, on the control station, remove the two screws securing it to the control panel.
2.
Open the control station.