Labrie Automizer Versa Hand, Maintenance Manual

Page: 33 / 190

General Maintenance 25
6.
Finish cleaning the area with pressurized water.
Inspecting After Clean-up
Once you are finished cleaning the hopper area, inspect your work:
1.
Check the following components for proper working order and/or alignment:
• Rollers
• Cylinder pins
• Hoses, pipes, connections, and cylinders (for leaks, etc.)
• Bolts (for thightness)
• Hopper floor and sidewalls (for excessive wear)
Figure 3-8 Inside the hopper area
2.
After inspection, put the floating panel back in place (see Figure 3-5).
3.
Use the stepladder to get down.
4.
Retract the stepladder.
5.
Start the engine, engage the hydraulic system and fully retract the packer.
6.
Retract the lifting arm alongside the vehicle.
Packer
The A
UTOMIZER
V
ERSA
H
AND
™ packing system relies on a heavy-duty guiding system and high-
strength steel wear plates. Because the packing system is put to such intensive use (1,000 to
3,000
cycles per day), Labrie Environmental Group recommends that
operators
perform a daily visual
inspection of the packer and its components.
Maintenance personnel
must
perform weekly inspection and maintenance. Greasing all moving parts
on a daily basis is very important and proper adjustment of the proximity switches is mandatory,
especially on vehicles equipped with a multi-cycle feature. For more information on the lubrication
schedule, see
Lubrication on page 75.
Side rail
Packer
cylinder
Roller