Labrie Automizer Versa Hand, Maintenance Manual

Page: 36 / 190

28 General Maintenance
3.
Extend the packer panel to within 12 inches of the end of the stroke.
N
OTE
:
To extend (or retract) the packer over a short distance, push the green (or yellow) button and
then push the red button immediately. Repeat the process until the packer has reached the
desired position.
4.
Turn off the hydraulic pump and the engine.
5.
Lock out and tag out the vehicle (see Locking out and Taging Out the Vehicle on page 10).
6.
Remove the packer cylinder access cover on the packer panel.
Figure 3-11 Packer cylinder access cover
7.
Remove the rear cylinder pins.
Removing the Packer Panel
Once you have prepared the packer panel for removal, you can now proceed with the removal.
To do so:
1.
Attach a suitable chain/cable to the packer panel and pull the panel towards the rear of the body.
N
OTE
:
When pulling the follower panels, they must be properly supported.
2.
If necessary, carry out the procedure for replacing floor guides (see Floor Guides on page 44).
3.
Reassemble in reverse order.
Danger!
Do not enter the hopper while the packer is moving.