Labrie Automizer Versa Hand, Maintenance Manual

Page: 69 / 190

General Maintenance 61
Figure 3-54 Packer retracted about one inch before end of stroke
3.
When the packer reaches the correct position, push the red emergency S
TOP
button.
4.
Lock out and tag out the vehicle (see Locking out and Taging Out the Vehicle on page 10).
5.
Locate the packer retract proximity switch on the right-hand side of the body (see Figure 3-53).
6.
Loosen both bolts and adjust the proximity switch so it is active when the packer reaches this
position (see Figure 3-55). At that point, the switch should be under the plate.
N
OTE
:
When the proximity switch is triggered by the plate during normal operation of the truck, an
amber light located on the switch turns on.
7.
Tighten back up both bolts.
8.
Make sure that the proximity switch detects the plate properly.
Ideally, there should be a gap of approximately 3/16 of an inch between the proximity switch and the
plate. If this is not the case, apply the following procedure:
To adjust the gap between the proximity switch and the plate:
1.
On the proximity switch, loosen the nuts located on each side of the proximity switch bracket
(Figure 3-55).
2.
Push or pull the proximity switch until there is a gap of 3/16 of an inch between the plate and the
switch.
3.
Tighten up both nuts.
4.
Make sure that the proximity switch detects the plate properly.
5.
Test the packer for a full cycle.