Labrie ALLEY -GATOR RIGHT-HAND, Maintenance Manual

Page: 67 / 108

Maintenance 57
Note that the proximity switch indicator light will be ON. ENSURE the proximity switch gap is
approximately ¼".
9.
TIGHTEN the proximity switch mounting nuts.
10.
INITIATE an AUTOPACK cycle and observe the sweep of the pendulum.
11.
If no more adjustment is needed put back the protective cover.
Figure 3-28 Return proximity switch and tab
In the PACK MODE , the pendulum should complete a full sweep and enter the body chamber by
several inches without the cylinders bottoming out (fully stroked). Repeat steps 2 through 5 as
necessary.
In the RETURN MODE , the pendulum should travel fully forward in the bowl and stop before the
cylinders bottom out (fully retracted). Repeat steps 6 through 9 as necessary.
N
OTE
:
The autopack cycle should be checked with the engine running at 1500 rpm. The pendulum
should transition smoothly between the PACK and RETURN cycles with no banging at the top
and bottom of the motion.
Tailgate Unlocked Proximity Switch
The tailgate unlocked proximity switch is located on the streetside of the tailgate near the rod-side
cylinder head (see Figure 3-29).
This switch gets triggered when the cylinder casing is sufficiently near the switch head. This occurs
when the cylinder is fully retracted.
Cycle Times
At idle 18 seconds
At 1500 rpm 12 seconds