Maintenance
33
trapped contaminants that are conducive to your system. Consideration needs to be given to the
operating conditions and duty when further determining the replacement interval.
Replacement
procedures for both types of filters are detailed on the
following pages.
N
OTE
:
The element must also be changed following a major hydraulic component failure.
Please consider the following recommendations by Labrie Enviroquip Group when replacing your
filters.
I
n-Line Pressure Filter (2)
5 micron
Return Line Filter (in tank)
10 micron
Hydraulic Return Line Filter
A
10
micron return line filter
element is located inside the hydraulic tank. All oil returning to the
hydraulic tank is passed through this filter. The filter is fitted with a filter restriction indicator that
signals time of replacement. Please see above for the recommended replacement filter. Filters may be
ordered directly from Labrie Enviroquip Group by calling our Parts Department.
N
OTE
:
Change the filter before the arrow of the filter restriction indicator reaches the red zone. This
will keep the oil clean, extend component life and reduce failures.
Figure 3-5 Filter restriction indicator
In-Line Pressure Filter
This
5 micron in-line pressure filter
is located under the chassis, behind the lift (see Figure 3-6).
Hydraulic oil is passed through this filter. This filter is also fitted with a pop-up indicator that signals
time of replacement. Please see above for the recommended replacement filter. Filters may be
ordered directly from Labrie Enviroquip Group by calling our Parts Department.
Summary of Contents for ALLEY -GATOR RIGHT-HAND
